Chuyển đến thông tin sản phẩm

B-800 Dispensing Controller

B-800 Dispensing Controller

Giá thông thường $81.30
Giá thông thường $81.30 Giá bán
EXW China
SAVE $-81.30 Đã bán hết

Mobel:  1150D
● MOQ :  1 set
● Packing details:  
● Subject to discussion:

Technical Data:

→ Power consumption: 8W

→ Air source: max 0.99 Mpa   Pressure setting: 0.05-0.99 Mpa

→ Time setting: DIP switch 0.01-1s; 0.1-10s; 0.2-20s; 0.3-30s

→ Control mode: Manual / Quantitative (fixed volume dispensing)

→ Repetitive accuracy: ± 0.05%   Dispensing frequency: 600/min

→ Min. dispensing volume: 0.01 ml

→ Dimension: 235mm x 225mm x 63mm     Weight: 2.2 Kg

Applications:

→ Materials for dispensing:

   solder tin, tin paste, UV adhesive, lubricant, epoxy resin,

   fast cure adhesive, silicone resin, etc.

→ Usage: adhering, fixing, dot coating, line coating, etc


Xem toàn bộ chi tiết

FAQ

The controller is displaying an error message. How can I resolve this?

Refer to the user manual for error code explanations and troubleshooting steps.
Perform a system reset if recommended by the manufacturer.
Contact technical support if the issue persists or for further assistance.

The B-800 is not dispensing materials correctly. What should I check?

Ensure the dispensing tool is properly connected and securely attached to the controller.
Verify the dispensing parameters such as time, pressure, or volume settings are correctly configured.
Check for any blockages or air bubbles in the dispensing system that may affect performance.

How do I calibrate the B-800 Dispensing Controller?

Step 1: Follow the calibration instructions provided in the user manual specific to your dispensing tool and material.
Step 2: Use calibration weights or measurement tools to verify dispensing accuracy.
Step 3: Adjust the controller settings as necessary to achieve accurate dispensing.

How often should I calibrate the B-800 Dispensing Controller?

Calibration frequency depends on usage and the specific requirements of your application. Generally, calibration should be performed periodically, especially if there are changes in materials or dispensing conditions.